Marine Structures & Fabrication

Hull blocks, superstructures, foundations, hatch covers, ramps and other fabricated marine structures.

S = 600Stiffener fit-up and alignment1Weld visual quality and size2Material grade marking and traceability3Distortion and plate fairness4Overall dimensions and squareness5
Illustrative process visualization

Structural fabrication quality is built step by step: material identification, cutting, fit-up, welding sequence, distortion control and dimensional accuracy. Defects found after coating or erection are many times more expensive to correct.

Inspection checkpoints

The numbers correspond to the checkpoints marked in the diagram above. Select a point in the diagram to jump to its explanation.

  1. Stiffener fit-up and alignmentBefore welding, stiffeners are checked for position, straightness and gap, and for alignment with the members on the other side of the plate. Misalignment found later needs cutting and re-welding.
  2. Weld visual quality and sizeWelds are examined for profile, undercut, porosity, cracks and missed runs. Fillet leg length and throat are measured with gauges and compared with the drawing and the acceptance standard.
  3. Material grade marking and traceabilityGrade and heat number are verified on plates and sections against the certificates, and transferred to each cut piece. Higher-strength and special grades must be used where the drawing requires them.
  4. Distortion and plate fairnessPlate between stiffeners and the straightness of frames are measured after welding and compared with the shipbuilding quality standard. Excessive distortion affects appearance and buckling strength.
  5. Overall dimensions and squarenessLength, breadth, height, diagonals and the position of the joining edges are measured. Blocks that are out of square cause gaps and misalignment at erection.

Typical documentation

Material certificates, cutting and marking records, WPS and welder lists, NDT reports, dimensional reports.

Related inspection and engineering services