Propellers & Propulsion Systems

Fixed and controllable-pitch propellers, shafts, stern tubes, seals, thrusters and waterjets.

Blade geometry: pitch, thickness and edge form1Hub bore and cone fit contact2Shaft and liner dimensions, NDT records3Seal and bearing clearances4Static balance and surface finish5
Illustrative process visualization

Propellers are cast in copper alloys or stainless steel and machined to tolerance classes. Geometry, surface finish and balance directly affect efficiency, noise and vibration. Thrusters and waterjets add gearboxes, hydraulics and control systems to the same concerns.

Inspection checkpoints

The numbers correspond to the checkpoints marked in the diagram above. Select a point in the diagram to jump to its explanation.

  1. Blade geometry: pitch, thickness and edge formPitch, blade thickness and edge shape are measured at several radii and compared with the tolerance class of ISO 484. Deviations affect delivered power, cavitation and noise.
  2. Hub bore and cone fit contactThe hub is fitted to the shaft cone with marking blue. The contact area must reach the specified percentage and be evenly distributed. Push-up distance and pressure are recorded when the propeller is mounted.
  3. Shaft and liner dimensions, NDT recordsShaft diameters, liner fits and surface finish are measured. Records of ultrasonic and surface crack testing are reviewed, with attention to the cone, the keyway area and liner ends.
  4. Seal and bearing clearancesBearing clearances are measured at installation and recorded as the reference for later wear-down readings. Seal parts are inspected for damage and correct assembly, as leakage is discovered only afloat.
  5. Static balance and surface finishStatic balance is checked on the balancing stand and corrected by removing material from the specified areas. Blade surface roughness is measured, since it has a direct effect on efficiency.

Typical documentation

Propeller measurement report, casting and material certificates, NDT reports, balancing report, class certificate.

Related inspection and engineering services