Piping, Fittings & Flanges
Pipe spools, fittings, flanges, expansion joints and supports in steel, stainless, copper-nickel and GRP.
Marine piping must match the P&ID, the pressure class and the corrosion environment. Typical findings concern wrong material grades, mixed flange standards, missing traceability and inadequate internal cleanliness.
Inspection checkpoints
The numbers correspond to the checkpoints marked in the diagram above. Select a point in the diagram to jump to its explanation.
- Flange standard, rating and facingFlange standard, pressure class, facing and drilling are verified on both sides of every joint. Mixed EN, ASME and JIS flanges are a frequent cause of fit-up problems on board.
- Spool dimensions against isometricSpool lengths, branch positions, flange rotation and squareness are measured against the isometric drawing, so that the spool fits on board without forcing.
- Weld quality and internal root conditionOutside, the weld is examined visually. Inside, the root is checked for penetration, excess material and oxidation, by borescope where access is limited. Stainless roots are checked for discolouration from poor purging.
- Pressure testSpools or systems are tested at the specified pressure with a calibrated gauge of suitable range. The pressure is held for the required time while joints are examined.
- Material grade, marking and cleanlinessMaterial marking is compared with certificates and with the pipe specification. Internal cleanliness is checked, and pickling, passivation or galvanising is verified before the ends are capped.
Typical documentation
Isometrics, material certificates, weld records, pressure test certificates, galvanising or coating records.