Offshore Equipment
Offshore cranes, winches, A-frames, launch and recovery systems and other mission equipment.
Offshore equipment is designed to specific codes with high dynamic loads, demanding material toughness, extensive NDT and full traceability. FAT programmes are long and overload tests need careful preparation.
Inspection checkpoints
The numbers correspond to the checkpoints marked in the diagram above. Select a point in the diagram to jump to its explanation.
- Main load-bearing structure and weldsPrimary structure is checked for material grade and toughness, weld quality and the full extent of the specified NDT. Traceability from plate to finished member is verified.
- Winch drum, brakes and spoolingDrum capacity, brake holding force and the spooling device are tested. The rope must lay evenly at all layers under tension.
- Wire rope, sheaves and terminationsRope certificates are checked for construction and breaking load. Sheave grooves are gauged for the rope diameter, and terminations are inspected for correct assembly.
- Foundation interface dimensionsThe bolting pattern, levelness and position of the equipment base are measured and compared with the vessel's foundation drawing before shipment, because correction on board is costly.
- Overload and function testsThe overload test is carried out with certified weights or a calibrated load cell at the specified radius. All motions, limits and emergency functions are then demonstrated.
Typical documentation
Design approval documents, material and NDT records, FAT procedure and report, load test certificates.