Welding & Fabricated Components

Welded components and assemblies in carbon steel, stainless steel, duplex and aluminium for marine service.

S = 600Fit-up, root gap and edge preparation1Welding parameters against the WPS2Welder qualification and identification3Visual acceptance to the specified quality level4NDT extent, timing and results5
Illustrative process visualization

Welding is a special process: its result cannot be fully verified afterwards, so control must be exercised before and during welding. QUAY's welding surveillance is carried out by qualified welding engineering personnel.

Inspection checkpoints

The numbers correspond to the checkpoints marked in the diagram above. Select a point in the diagram to jump to its explanation.

  1. Fit-up, root gap and edge preparationJoint geometry is checked before welding: bevel angle, root face, root gap, alignment and cleanliness. Most weld defects start with a poor fit-up, which is why it is often a hold point.
  2. Welding parameters against the WPSCurrent, voltage, travel speed, preheat and interpass temperature are measured during welding and compared with the ranges of the welding procedure specification. Consumable type and batch are recorded.
  3. Welder qualification and identificationEach welder's certificate is checked for process, material group, thickness, position and validity. Welds are marked or mapped so that every joint can be traced to the person who made it.
  4. Visual acceptance to the specified quality levelFinished welds are examined over their full length for cracks, lack of fusion, undercut, porosity and profile, and judged against the specified quality level, for example ISO 5817 level B or C.
  5. NDT extent, timing and resultsThe NDT plan is checked for method, percentage and location, and for the required delay after welding where hydrogen cracking is a risk. Reports are reviewed, and repairs are tested again.

Typical documentation

WPS, PQR, welder certificates, consumable certificates, weld maps, NDT and heat treatment records.

Related inspection and engineering services